NSE7_SDW-7.2 Online Practice Questions

Home / Fortinet / NSE7_SDW-7.2

Latest NSE7_SDW-7.2 Exam Practice Questions

The practice questions for NSE7_SDW-7.2 exam was last updated on 2025-04-26 .

Viewing page 1 out of 8 pages.

Viewing questions 1 out of 43 questions.

Question#1

Which two tasks are part of using central VPN management? (Choose two.)

A. You can configure full mesh, star, and dial-up VPN topologies.
B. You must enable VPN zones for SD-WAN deployments.
C. FortiManager installs VPN settings on both managed and external gateways.
D. You configure VPN communities to define common IPsec settings shared by all VPN gateways.

Question#2

What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
B. It improves SD-WAN performance on the managed FortiGate devices.
C. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
D. It acts as a policy compliance entity to review all managed FortiGate devices.
E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

Question#3

Refer to the exhibit.



Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

A. All traffic from a source IP to a destination IP is sent to the same interface.
B. All traffic from a source IP is sent to the same interface.
C. All traffic from a source IP is sent to the most used interface.
D. All traffic from a source IP to a destination IP is sent to the least used interface.

Explanation:
Study Guide 7.2, page 176.

Question#4

Refer to the exhibit.



Which conclusion about the packet debug flow output is correct?

A. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
B. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
C. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
D. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

Question#5

Refer to the exhibit.



The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

A. Each BGP route is three hops away from the destination.
B. ibgp-multipath is disabled.
C. additional-path is enabled.
D. You can run the get router info routing-table database command to display the additional paths.

Exam Code: NSE7_SDW-7.2Q & A: 122 Q&AsUpdated:  2025-04-26

 Get All NSE7_SDW-7.2 Q&As